System Monitor

Loading samples, reagents, controls and calibrators is done using an exact digital replica of the instrument’s panel and this allows the operator to immediately recognize all required steps.

Reagents’ levels, cuvette status and other checks are displayed in the System Monitor Screen.

Workplan Setup

After having loaded all required reagents, controls, calibrators and samples, the operator is prompted to set-up the work plan, including any required IF-THEN testing as per method or laboratory requirements.

Calibration Curve

Calibration can be run automatically from the SmartChem® 200 software and it uses only a concentrated standard, because the analyzer will make the relevant dilutions as defined by the standard points in the calibration.

Workplan

Once the test routine is finished, all results are presented in a report that can be exported to LIMS.

Levey-Jennings QC Graph

For laboratories using control samples, the SmartChem® 200 software includes Levey-Jennings QC Graphs that allow the laboratory to see not only the validity of the analytical series run, but also to see any potential trends in the QC samples that may indicate a need to undertake preventive actions well before any issues may arise.